Page 1 of 1
Peak LED question, maybe a dumb one
Posted: Sat Feb 04, 2012 9:29 am
by Blad09
On the PLD1, is there any way to tap into the peak LED to add another one that could be mounted in sight, maybe beside the LPL? Just thought since most line drivers get mounted in the glove box or out of sight it would be sweet to have that LED showing and it would look sweet beside the BASSCUBE remote too. Just a thought.
Re: Peak LED question, maybe a dumb one
Posted: Sat Feb 04, 2012 10:20 am
by valeks1
Re: Peak LED question, maybe a dumb one
Posted: Sat Feb 04, 2012 4:09 pm
by Blad09
Wish I knew how to read schematics lol. Is that a yes then?
Re: Peak LED question, maybe a dumb one
Posted: Sun Feb 05, 2012 8:50 am
by Blad09
Alright, I did some reading about elec. components. I know what I'm looking at now lol. Only other question regards parallel or series wiring?? I think either way I would have to add a resistor along with the 2nd LED... is that correct? Valeks, would u be so kind as to draw me the circuit with a 2nd LED added. Thanks.
Re: Peak LED question, maybe a dumb one
Posted: Sun Feb 05, 2012 10:10 am
by ttocs
that little triangle with the arrows comming out of it on the right, thats the led.... The circuit he has drawn will not place any additional load on the amp. Just adding a 2nd led and a resistor will not work.
Re: Peak LED question, maybe a dumb one
Posted: Sun Feb 05, 2012 11:08 am
by Blad09
"The circuit he has drawn will not place any additional load on the amp".... Not sure what u mean, but if it won't work that's what I was after so thank you!!
