Page 1 of 1
need ideas for new car
Posted: Sat Feb 04, 2012 3:34 pm
by todd217
i just bought a 2006 mustang gt with the factory 8s and 5x7s in the doors. here is what i have in my inventory ms1000ta, m25, rt66, t500.2, ms275, idmax 12, rsd 12, tc sounds tc2000 12, tc sounds oem 10, 4 kicker c12c, jbl ms8, alpine cda 9887 with imprint, pg ti6.5cs, image dynamics xs 5x7 comps the factory pods for the 8s are about .3 cuft and have a max depth of 3.5"
the only thing im set on using is the ms1000 and i must have usable trunk space. if you were going to do this what would you do?
Re: need ideas for new car
Posted: Sat Feb 04, 2012 3:50 pm
by ttocs
can you go with out the back seat?
Re: need ideas for new car
Posted: Sat Feb 04, 2012 3:57 pm
by todd217
ttocs wrote:can you go with out the back seat?
need the back seat
Re: need ideas for new car
Posted: Sat Feb 04, 2012 5:31 pm
by ttocs
well the only place that thing will have a chance at fitting is betwen the rear shocks. Put that thing and a small sub and you should still have space.
Re: need ideas for new car
Posted: Sat Feb 04, 2012 6:09 pm
by todd217
the two ideas i have for the subs are either the idmax in the corner or the 4 kickers isobaric behind the seats.
Re: need ideas for new car
Posted: Sat Feb 04, 2012 7:12 pm
by ttocs
4 subs and a ms1000ta = little to no trunk space. I am planning on 3 behind my seat and filling my spare tire area to keep some usable space in my mustangs trunk.
Re: need ideas for new car
Posted: Sat Feb 04, 2012 7:51 pm
by todd217
If I run them isobaric I'm only looking at a 1.75 cuft box
Re: need ideas for new car
Posted: Sat Feb 04, 2012 8:35 pm
by ttocs
and that sounds really small until you look at the opening for the trunk. I am afraid you would end up building it in the car. As it sits now with my 3 10's I am going to probably build 3 seperate boxes to make it easier to install and take out when needed.