Hi,
Today I have clean my pcb but at one time I have touch one kind of " orange gain screw" and it turn for 1 millimeter, I think it's a kind of adjustment but I'm not sure, can someone help me on this?
I want to hit my head on the wall this is stupid of my part I know it
this is a photo of this screw:
little mistake on my ms-2125
-
- Posts: 1653
- Joined: Sun May 06, 2012 8:01 am
Re: little mistake on my ms-2125
Thats to adjust the bias. You'll have to check the emitter's voltage and adjust it according to spec.
It looks like you have two bad caps (C213 & C119) according to the pics. Or their just "sun burned" and might be perfectly fine.
It looks like you have two bad caps (C213 & C119) according to the pics. Or their just "sun burned" and might be perfectly fine.
-
- Posts: 40
- Joined: Thu Apr 12, 2012 12:27 pm
Re: little mistake on my ms-2125
I think their "sun burned", the amplifier works good
Re: little mistake on my ms-2125
Not a good idea to touch those. If you can put it back where it was before, you should be alright, but I wouldn't risk running the amp otherwise.
Re: little mistake on my ms-2125
A little recommendation from someone that recapped and cleaned one or two of those: "Always mark those with nail colour or tippex before u start cleaning the amp"
Music is silver, PHOENIX is GOLD