Page 1 of 1

FAS value

Posted: Tue Aug 21, 2012 7:28 pm
by Bigred41291
Just got this in a trade no idea what its worth not trying to sell unless a good offer came along, just want to know if I got the better deal. I traded a set of 22 inch rims that needed to be re-surfaced and re-chromed and needed new tread. Amp powers on. Also I noticed that the specs say 510wrms X 1ch@ 4ohm is this amp 2 ohm stable, 1 ohm? Any help would be great.

Re: FAS value

Posted: Tue Aug 21, 2012 10:36 pm
by Mr. Wild
Nice! I would take a frank over a worn set of rims any day of the week.
If you decide to use it make sure it has new power supply caps.

Its definitely 2 ohm stable bridged and will make about 700W RMS or 1000W dynamic.
You just have make sure it has adequate cooling and power.

Re: FAS value

Posted: Tue Aug 21, 2012 10:43 pm
by Bigred41291
Yea I gave the 2ch. Side power for about 1sec. Just to make sure it would power on but it's going to sit on a shelf untill I can afford to have the caps replaced. Any idea on it's value?

FAS value

Posted: Wed Aug 22, 2012 3:46 am
by todd217
At least 700 is the plexiglas cracked? The end plates don't look bad. Any nicks in the powder coat on the sink?

Re: FAS value

Posted: Wed Aug 22, 2012 6:33 am
by joerg
Broken fins, paintflaws, leaking caps, scratched to death plexi, rusty screws which leads to rusty endplates. Probably worth arround 600USD if the right person shows up

FAS value

Posted: Wed Aug 22, 2012 6:51 am
by todd217
Man I could not see all those issues in the phone looking at it. The broken fins is what will really hurt the the value as they can't be fixed.

Re: FAS value

Posted: Wed Aug 22, 2012 6:56 am
by Bigred41291
No the fins are fine il post more pix today it really seemd like it needs fresh paint some new plexi screws (I'm missing a few), and acap replacement this thing is nowhere near mint but I was suprised by the condition of the amp.

Re: FAS value

Posted: Wed Aug 22, 2012 7:35 am
by Bigred41291
Pix of the damage.

Re: FAS value

Posted: Wed Aug 22, 2012 10:33 am
by joerg
If the fins in the very first picture u posted are not broken and only missing some paint i correct it´s value up to arround 700USD

Re: FAS value

Posted: Wed Aug 22, 2012 12:48 pm
by Bigred41291
And as for the plexi being scratched there is a small scratch in the "n" in frank and another minor scratch in the "s"

Re: FAS value

Posted: Wed Aug 22, 2012 7:42 pm
by Bigred41291
Also have this fan wire looks like it was never even hooked up