Page 1 of 1
RSD IC pads
Posted: Wed Aug 22, 2012 10:08 am
by Drock
I took my RSD 1200.1 apart and lost one of the little clear pads that go between the IC and heat sink. ( not sure what the proper name for this is)Does any one have these or an old dead amp for parts?
Re: RSD IC pads
Posted: Wed Aug 22, 2012 11:01 am
by ttocs
sil-pad. Sorry I am out.
RSD IC pads
Posted: Wed Aug 22, 2012 8:52 pm
by Drock
To bad. Thanks though. Maybe someone else has some.
What exactly is the purpose of the sil-pads? Is it an insulator or a conductor? It's the first time I took a good amp apart and had to put it back together. I thought I had everything accounted for but I guess not. Now I'm not wanting to power it up to try it out.
Re: RSD IC pads
Posted: Thu Aug 23, 2012 4:17 am
by ttocs
they often get stuck to the back of a transistor or two check them out to make sure they are not sticking to them.
Re: RSD IC pads
Posted: Thu Aug 23, 2012 6:21 am
by shawn k
I'm assuming it's for a transistor?
Shoot me a good close up pic so I can determine the size of sil-pad you need. I can either send you a couple if I have the correct size, or at least point you in the right direction to purchase some.
RSD IC pads
Posted: Thu Aug 23, 2012 4:29 pm
by Drock
shawn k wrote:I'm assuming it's for a transistor?
Shoot me a good close up pic so I can determine the size of sil-pad you need. I can either send you a couple if I have the correct size, or at least point you in the right direction to purchase some.
thanks Shawn. I'll open it up and take some pics in a bit.
RSD IC pads
Posted: Thu Aug 23, 2012 7:46 pm
by Drock
Here are the pics.
- ImageUploadedByTapatalk1345779848.772744.jpg (50.68 KiB) Viewed 3208 times
- ImageUploadedByTapatalk1345779867.755661.jpg (46.77 KiB) Viewed 3208 times
They look like they are about 1/2" x 3/4"
Re: RSD IC pads
Posted: Thu Aug 23, 2012 8:18 pm
by shawn k
They appear to be TO220 casings. I can send you a couple. Shoot me your address in a pm.