Phoenix Gold Phorum

So i have a few Bass cubes (3) and i do have a working remote. My issue is one of them is missing the outer contact on the L input RCA. Can i just slide a new or spare piece over the plastic or should i replace the whole RCA lead?



They are all a little different. One Ti, 2 white. One has black screening, the other grey. Its funny how they differ from screw type to case shape.
[imhttps://fbcdn-sphotos-g-a.akamaihd.net/hphotos-ak-ash3/541244_10152099588235313_1142102507_n.jpg][/img]

One is significantly rougher than the rest but since my entire system is old school, with no Ti, i wish to run 2 white cubes (multiple sub amps) to a line splitter, then a single remote. Would this work?

Pic didnt work. I guess it is kinda about the remote, damn

normally the whole rca connector needs to be replaced but its not that big of a deal.

The outer metal part is how the ground reference signal/shield is received by the device. You can probably try sliding it back on, but those jacks are very inexpensive and pretty simple to remove/replace so I would just replace it. Some googling and a few practice runs with the soldering iron should have anyone able to do it.

http://www.apexjr.com/Jacks.htm

Sweet, thanks guys

I have found a guy with 30 years soldering experience to do the burning on my caps so i think im going to go that route. it will be alot faster with less chance of screwing a board. Pretty reasonable as well. Ill just throw this in the pile, lol.