Phoenix Gold Phorum

just a little quick question......

my titanium 1000,2 is having a little isue......nearly no output...but when i touch the "input sensitivity" it is giving some burps and sometimes the one channel is playing.....(sometimes both) ....i would guess it is a bad potentiometer....will it fit from a 600ti ? (i have one lying around i have ripped for spares)...

Try this one time. turn the amp off.

turn the gain 2O times up and down. or from totally open to totally closed.....

Sometimes this works......sometimes.....not.....

i would give this first a shot, then turn the amp on and see if it helped......

just tryed it......still only one channel working...but only at full open....just it gets turned just slightly down it´s not working....

http://www.ebay.com/itm/NEW-ALPS-50K-Po ... 45f9ef5a0a

not sure about the ti series, is it this pot that's in ??

how long do you have this problem ? recently ??

are you sure the problem is inside the amp ? if you connect the input rca to another amp, does it play fine ??

I would check this first before starting to work inside of the amp.........

i havent opened it yet.....but yes i have tried to hook up other rca signals to it...but still the same result....

ill have a look at it again tomorrow....getting evening here in denmark now.....

found the error burned one of my 8" boston mid bass

tattooemil wrote: found the error burned one of my 8" boston mid bass

maybe somebody here around knows where there to find a recone kit ?? they can be reconed........