Page 1 of 1
Xenon 200.4....power terminals
Posted: Mon Dec 03, 2012 6:33 pm
by Audiophiliac
I know you are supposed to use both sets. The one i just picked up on eBay looks like it had been used with only one set connected. I have not fired it up yet. What could only using one set of the terminals cause? The inside looks really clean. No dust on the fans even. I hope it works ok. It was cheap. :]
Re: Xenon 200.4....power terminals
Posted: Mon Dec 03, 2012 7:10 pm
by Eric D
I am pretty sure using both is an option, not a requirement.
Re: Xenon 200.4....power terminals
Posted: Tue Dec 04, 2012 4:25 am
by dwnrodeo
Eric D wrote:I am pretty sure using both is an option, not a requirement.
Agreed. Unless you are REALLY drawing a lot of current, only one terminal is fine. I've been using mine that way for the last 5 years with no problems in various different configurations.
Re: Xenon 200.4....power terminals
Posted: Wed Dec 05, 2012 2:22 pm
by Bfowler
if you use it a t 4ohms per channel, no problem