Phoenix Gold Phorum

Hello, a basic question: my system will compose of two xenon amp, a 200.4 and 600.1, with a front component speakers and a 6x9 rear. The 600.1 for the sub. My HU is an Alpine 121, I stay with it or I need to change someone have more RCA? as this http://www.kenwoodusa.com/Car_Entertain ... DC-BT752HD

I'm not sure if your HU has 2 RCA outs, but you can run one set of RCA's to either amp, then run a short set OUT to the IN of the other amp.

alpine 121? never hear o fgtyou don't need to upgrade to get more rca's you can always split them although you will not bet the abiltiy to balance/fade the stereol. By upgrading you would also possibly get a subwoofer rca output which is always nice as it gives you the ability to give the sub a little more volume from the deck seperatly from the rest of the speakers.

another option is to use the rca aux outputs on the 200.4 to send signal to the x600.1 and then use an lpl on the x600.1 to control the sub volume

Bfowler wrote:another option is to use the rca aux outputs on the 200.4 to send signal to the x600.1 and then use an lpl on the x600.1 to control the sub volume

Easiest way to do it with the gear you already have.

Francious70 wrote:

Bfowler wrote:another option is to use the rca aux outputs on the 200.4 to send signal to the x600.1 and then use an lpl on the x600.1 to control the sub volume

Easiest way to do it with the gear you already have.

Bfowler wrote:another option is to use the rca aux outputs on the 200.4 to send signal to the x600.1 and then use an lpl on the x600.1 to control the sub volume

Thanks!