Phoenix Gold Phorum

I am building new system again. If I can't find MS 1000 TA I might use my Octane LE amp. But there is a problem. It has only one RCA input pair. I would need 2 separate inputs for full active system.

Is it possible to modify amps output lines to inputs? Has anyone done this? If so, how?

need a 1000ta? I have one.

Back to the Octane...I haven't played around with one yet, I'm sure some will know.

Welcome to the forum

vin78, PM sent.

You would have to have a second input card < I might have one laying around here from a ZX amp, in fact I am sure I do>

But it will require much modding to the LE amp and the power supply might not be able to handle the extra load of the input card on its 16 volt rails. I do strange things like this for folks here on the forum, but your talking a fair piece of money and work to achieve what your asking.
You might consider another amp like the 1000 rather than spend money in a custom one off amp mod like this. LMK C

The Octane LE has a built in BassCube IIRC the signal is routed from them inputs of the primary amp through the basscube and then into the secondary amp. You should be able to just interrupt that signal prior to the BQ and be fine..........again I wouldn't really suggest modding a rare amp like that.

Ok, maybe it is better to leave modding plans then. I didn't think it would be that difficult.

THX Eerin, I was planning on adding the channels he said he did not have