Phoenix Gold Phorum

OK I ended up having to cut off the old Phoenix Gold power distribution blocks that bolted to the top of my battery. They are shot and cannot be saved. I am having a lot of trouble coming up with a comparable replacement.

These blocks were from about seven years ago, had two fuses across the top--well the positive one did, and accepted two 1 gauge wires. They bolted on top of the battery posts.

The way the car is wired and the path it takes, I really need a new set of blocks that can do the same thing. There is no room to run a separate distribution block and battery terminals.

Is anyone familiar with a product that can be used in this application?

Regards
Mister Pig

Just checked ebay italy and found out that the seller that used to have them sold all of his stock already. A piece was 34,95eur plus shipping

Yeah at this point, I am just looking for a comparable replacement, from any manufacturer. It needs to attach to a top post battery, have fuses, and accept 2 1 gauge wire.

Anyone see any alternatives?

Regards
Mister Pig

i dont know of any manufacturer that made comparable models, but pg did make 2 versions that will work for you.
the tmc.902 and PF1FPBT (you had the tmc, the newer one doesnt have the bolt for a ring terminal in back

also it can be had in the "akit-1" amp kit which this site "says" is for sale. i have never heard of it and dont know how reputable they are:

http://www.rakuten.com/prod/phoenix-gol ... 18449.html