Page 1 of 1
zx250 power connector
Posted: Sun May 26, 2013 8:58 am
by bunch62
Can the power/remote connector for the zx250 be changed to the type fitted on the other zx range thanks Allan
Re: zx250 power connector
Posted: Mon May 27, 2013 4:27 am
by trickyricky
bunch62 wrote:Can the power/remote connector for the zx250 be changed to the type fitted on the other zx range thanks Allan
Is the original damaged? It can be swapped out but some mods will be required to the panel as the others use a bigger block.
Re: zx250 power connector
Posted: Mon May 27, 2013 12:50 pm
by bunch62
It's not damaged but the amp requires servicing and trying to fit the 4 awg that the car is wired with without correct crimpers is a problem, and I wanted all amps wiring to match if possible
Re: zx250 power connector
Posted: Mon May 27, 2013 6:04 pm
by trickyricky
Contact altser, he has the terminal blocks that your looking for. I think he sells them for 20.00 each, ask him though. Like I mention you might have to dremel the side panel to fit the bigger block. Its possible.
Re: zx250 power connector
Posted: Mon May 27, 2013 11:27 pm
by bunch62
[quote=thanks trickyricky "trickyricky"]Contact altser, he has the terminal blocks that your looking for. I think he sells them for 20.00 each, ask him though. Like I mention you might have to dremel the side panel to fit the bigger block. Its possible.[/quote]
Re: zx250 power connector
Posted: Wed May 29, 2013 4:13 pm
by trickyricky
Just checked my 500.4 and i don't think it's possible to switch the power terminal. Double check.
Re: zx250 power connector
Posted: Thu May 30, 2013 10:33 am
by bunch62
Just compared the 250 with a 450, 250 is soldered 450 bolted plus main board totally different layout. May be possible but would require major mods, better to buy good crimper. But thanks trickyricky for the replies
Re: zx250 power connector
Posted: Sat Jun 01, 2013 10:08 pm
by trickyricky
Glad you saw it before buying blocks, your welcome.