Page 1 of 1
Sdt rddp schematics
Posted: Sat Nov 02, 2013 10:41 am
by freshkryp69
Anyone have schematics to the Sdt volt gauge, the "Dakota Digital" version.. Im trying to figure how to make the diag leds work with a non PG amp.. When looking into the female part on the gauge, I know pins 5 is (+) and pin 7 is the (-).. Im sure all the diag leds on the sdt gauge are triggered with a (+) signal..
thx
Re: Sdt rddp schematics
Posted: Sat Nov 02, 2013 12:46 pm
by dvnt88
^^^^ Here's what I have that was pulled from the manuals FTP on the phorum ...hope this at least helps out.
http://download.phoenixphorum.com/TechS ... Pinout.pdf
http://download.phoenixphorum.com/Manua ... ctions.pdf
Re: Sdt rddp schematics
Posted: Mon Nov 11, 2013 4:13 pm
by freshkryp69
Thanks bro, I have those to.. I just wanted to make sure 100% which wires were which as im going to use this sdt gauge with a different brand amp, which also has a protect and clipping leds..so If I can wire it up right then ill know whats up with the amp just like the PG amps..
Re: Sdt rddp schematics
Posted: Mon Nov 11, 2013 4:49 pm
by ttocs
not sure how I missed this but I can help. The R-link is basically just a piece that reads the led status of the power/over leds and repeats them but if I remember correctly from what I saw it was triggered by a negative signal. pm me and I think I can help.
Re: Sdt rddp schematics
Posted: Fri Jan 02, 2015 3:39 pm
by Alfaholic
Hi i saw this and i got a question, the RJ45 telephone cabel from the R-link to the display is that just a regular RJ same pin layout or are some changed?