Page 1 of 1

M50 replacment rca input connector

Posted: Sun Aug 17, 2014 2:17 pm
by Txsaxkat
I recapped this amp a few years back and it was a beast of a little amp but one channel quit and its the rca inputs I searched some and went to digikey and spent way too much time searching their. Looking for a part # and where to get.

Thanks
Jimmie

Re: M50 replacment rca input connector

Posted: Sun Aug 17, 2014 2:42 pm
by trickyricky
I may have an extra oem one. You can try panel mount style (Tiffany style), only downside is that you won't be able to complete remove the top cover.

Re: M50 replacment rca input connector

Posted: Sun Aug 17, 2014 5:37 pm
by Txsaxkat
The holes are really close together might not be enough room get both nuts on I guess I could enlongate the holes if I had too.

Jimmie

Re: M50 replacment rca input connector

Posted: Sun Aug 17, 2014 6:22 pm
by trickyricky
It can be done...I did it to my bass cube and it utilizes the same RCA jack. The base cube is much easier because the top cover is not attached to the RCA panel. These are way more durable and many times better than the originals, with these you can push and tug as hard as you want without worries about cracking/breaking solder joints.

Image

Re: M50 replacment rca input connector

Posted: Mon Aug 18, 2014 3:15 pm
by Txsaxkat
Thanks Im on it.

Jimmie