Page 1 of 1
Sound Board
Posted: Thu Dec 18, 2014 11:55 am
by Drock
So after moving some gear around. I decided to re-vamp the bench wall.
Still have lots to do, but its a good start.
I need to build some kind of mount so i can easily swap h/u's and eq's/processors in and out.
Sent from my iPhone using Tapatalk
Re: Sound Board
Posted: Sat Dec 20, 2014 6:17 am
by vwdude
Nice looking board. That wiring is giving me a headache. It's not poorly done but there's just a lot of it.
Have you gone through those powercores? I hope so, it would be a shame to see all of the equipment get damaged from a powercore explosion.
Re: Sound Board
Posted: Sat Dec 20, 2014 10:28 am
by Drock
^ lol, lots more wiring to do.
The power cores are mint. And i check them regularly. Well aware of the possible risks.
When the garage is done then ill be building a proper wall were all wiring will be hidden.
Till then this is my happy place.
Sent from my iPhone using Tapatalk
Re: Sound Board
Posted: Mon Jan 12, 2015 6:20 pm
by LowandLoud
Theres something missing..........
Oh ya, the EQ, lol
LL
Re: Sound Board
Posted: Mon Jan 12, 2015 9:03 pm
by CK1991
How do you make the wiring look so clean? What do you do for mounting the wires and routing them so tight? How do you attach wires to each other when they run side by side so they stay properly spaced? (Sorry for the questions, but I can't figure out how to make an install look super clean)