Phoenix Gold Phorum

Hey guys, i have a question about wiring speakers on my ti800.4 amps on my bench.

If i were to use say the front left/right ch's stereo at 4ohm to a ti passive crossover for mid and tweet,
Could i run a ti9 bridged on the same front ch's?
Im sure i did this way back once with an old kenwood kac-744 amp.
I think it was called tri-mode back then.

Would this work on most amps? Or was this a specific configuration for kenwood amps.

I just am curious.


Sent from my iPhone using Tapatalk

Different brands at some point had this option. But I nevered researched if PG amps could. It does bring up a good question thou.

Dont mean to thread jack ya but does anyone know if the originals ti and zx models allows this config also?

Yes the ti zx do
Look up the mps manual it show it there

Thanks Mike.


Sent from my iPhone using Tapatalk