Page 1 of 1
RMD ?
Posted: Tue Feb 03, 2015 12:37 pm
by NOT 2 OLD YET
I picked 1 up for my truck and after reading some older posts, it will not work with my ZBB34TI. MY Bad! Is it possible to hard wire the unit in and if so what are the color codes? Thanks Fellas!
Re: RMD ?
Posted: Tue Feb 03, 2015 12:52 pm
by trickyricky
Should be easy, figure out which pins on the ZBB are the negative/ground and positive, buy the correct module jack for the cable end on your RMD and rewire it. I believe the RMD has four pin/positions so its two positives and two grounds.
Re: RMD ?
Posted: Tue Feb 03, 2015 1:12 pm
by NOT 2 OLD YET
My thought was hard wire it in to the system off of the main relay. That way it will turn off also. I am just not sure which color will go where to make it work correct.
Re: RMD ?
Posted: Tue Feb 03, 2015 1:21 pm
by trickyricky
Am not familiar with those fancy fuse blocks, but I thought they had a remote terminal as well? Is the jack a RMD or RDDP? If its an RDDP then you might want to take a look at the PG info sheet on that.
Re: RMD ?
Posted: Tue Feb 03, 2015 1:38 pm
by ttocs
the jack on the fuse blocks is for the ZRT3 I think it is. Its just a single tri-colored led.
Re: RMD ?
Posted: Thu Feb 05, 2015 5:02 pm
by AVICJR
Search around the forum. I believe there is a pdf mod that shows how.
Sent from my iPhone using Tapatalk