Page 1 of 1
Elite .5 + Cyclone
Posted: Sat May 23, 2015 3:37 pm
by tetraag
Does it have enough power to run on the sub channel?
1100w @ 1ohm
800w @ 2ohm
???w @ 8ohm
If not, I'll take brand/model suggestions for 2x12's iso in a 4th order bandpass
Re: Elite .5 + Cyclone
Posted: Sat May 23, 2015 4:12 pm
by ttocs
the clone doesn't need a whole lot of power it should be fine
Re: Elite .5 + Cyclone
Posted: Sat May 23, 2015 4:15 pm
by kg1961
Power yes but you need a 24db cover not 18
edit I never seen the 2 different xover my bad sorry
Re: Elite .5 + Cyclone
Posted: Sun May 24, 2015 5:03 pm
by tetraag
Manual shows 18db slope minimum and I can eq out the upper range as well with the audio control dq-61
Re: Elite .5 + Cyclone
Posted: Mon May 25, 2015 1:38 am
by zeropoint0.5
http://www.phoenixgold.com/products/amp ... oductID=80
gentlemen, if you read good , it states that the sub channel is 24db/oct..........
it is the F/R crossover that is 18 db/oct..........
Re: Elite .5 + Cyclone
Posted: Mon May 25, 2015 7:31 am
by tetraag
I never realized there are two different xover slopes. Great eyes!
I'll give it a shot... or rather I'll have my buddy build up the box!