Phoenix Gold Phorum

Hi Folks,

Can anyone provide the dimensions of the PG Power Flow Cap?

I'm mid-build and my Cap is tied-up in the post. I want to make sure I provide sufficient space for the cap before I place the M Series Amps.

Thanks gang
Chris

Bump

Which one? 1farad or .5? They should be the same as any other old school stiffening cap.

Thanks bud, it's the 1.

I was thinking same size as other caps, just wanted to be sure

Chris

unless it has a voltage reading on the top they are almost all the same. Mine is mounted where I can't get to the bottom of it. Sorry.

Mine is a 1-farad without the digital read out and dimensions are : 3" diameter x 6.25" length w/studs and terminal (5.75" without studs or terminals).

Thanks so much for the dimensions bud

Chris