Page 1 of 1
What do you fill an enclosure with?
Posted: Sat May 07, 2016 9:41 am
by Bchester6
I have a fiberglass enclosure that is housing a Boston Pro 12.5 that I need to get down to the recommended 1 cubic ft. Right now I'm about .25 over. It may be nit-picking but it bugs me nonetheless. All recommendations are appreciated and welcome.
Re: What do you fill an enclosure with?
Posted: Sat May 07, 2016 11:19 am
by wooferdog
you could use that expandable foam if you can keep it under control. it does make a mess if you use too much but you can trim it after it sets up.
Re: What do you fill an enclosure with?
Posted: Sat May 07, 2016 11:30 am
by Eric D
Just make a 0.25 cuft MDF box (based on external dimensions, not internal), and glue it inside the fiberglass enclosure.
Re: What do you fill an enclosure with?
Posted: Sat May 07, 2016 2:36 pm
by ttocs
depending on how much you need if you can add some extra bracing it helps in more ways then one.
Re: What do you fill an enclosure with?
Posted: Tue May 10, 2016 3:21 pm
by Bchester6
Eric D wrote:Just make a 0.25 cuft MDF box (based on external dimensions, not internal), and glue it inside the fiberglass enclosure.
That did the trick. Thanks Eric.
Re: What do you fill an enclosure with?
Posted: Thu May 12, 2016 1:17 pm
by Eric D
Bchester6 wrote:Eric D wrote:Just make a 0.25 cuft MDF box (based on external dimensions, not internal), and glue it inside the fiberglass enclosure.
That did the trick. Thanks Eric.
Without photos it never happened...