help with ti2500.1

Need help with your car stereo system? Have a technical question? Post here.
Post Reply
shoban1
Posts: 4
Joined: Sun Jun 14, 2015 11:48 am

help with ti2500.1

Post by shoban1 »

I was just wondering if it's possible to run the ti2500.1 in a 0.5 ohm load. my electrical is sufficient. 320 amp alt. all 0 ga power and ground. ground is to the frame of the car. I have volt meter to watch.
Stravus
Posts: 120
Joined: Wed Feb 17, 2016 2:24 pm

Re: help with ti2500.1

Post by Stravus »

Lowest Recommended Load 1 Ohm
So that would be a No. The power supply and the heat dissipation were not designed to handle anything below 1 ohm.
vwdude
Posts: 1846
Joined: Sun Mar 31, 2013 11:55 am
Location: So cal

Re: help with ti2500.1

Post by vwdude »

My ti2 2000.1 has heat issues even at 3 ohms. I have a cross flow fan on its way to me, but I wouldn't even attempt .5 ohm stereo, let alone mono.
A few of these and a few of those.
Creator of www.phoenixgoldregistry.com
hit me up to add your limited edition amps.
Post Reply