Page 1 of 1
Xenon X1200.1 in Protection Mode
Posted: Fri Jul 15, 2016 6:49 pm
by AVICJR
I'm having my trunk re-done and somewhere in the process my X1200.1 went into protection mode (blue LED blinking). Everything was fine prior to the new work. Amp has no load. Any idea why this may be happening?
Thanks in advance.
Re: Xenon X1200.1 in Protection Mode
Posted: Sat Jul 16, 2016 9:20 am
by kg1961
I know its stupid to ask any loose strands of wire touch the other terminal or body of the amp?
Re: Xenon X1200.1 in Protection Mode
Posted: Sat Jul 16, 2016 2:32 pm
by AVICJR
kg1961 wrote:I know its stupid to ask any loose strands of wire touch the other terminal or body of the amp?
Not that I know of.
Sent from my iPhone using Tapatalk
Re: Xenon X1200.1 in Protection Mode
Posted: Sat Jul 16, 2016 9:18 pm
by trickyricky
Blue LED lights to indicate
the amplifier is on. The LED
will blink in 1 second intervals
if the amplifier goes
into protection mode. This
usually means the amplifier
is in need of service or a
grounded speaker wire is
present in the system.
Doubt that one of the outputs went out by simply removing it and then re-installing it. But if any loose strands of wire fell inside the amplifier then all sorts of problems can be caused..