Phoenix Gold Phorum

I have the Elite 5 component set. I don't use the PG's tweeters. I use the old infinity EMIT ribbon tweeters. I recently installed the Rockford fosgate TI15004 amp on them. there is too much tweeter output coming out of them now. I bought the amp to power my other mid and highs not my PG's components. I was running them through a zx450, but the rockford amp was so huge that I had to take it out.

anyway I know that there are level controls for the resistors on the passive crossover for the tweeter. however PG doesn't include any info on how to set them (PG has a history of being vague on their superior products). do any of you guys know?

I think you have to pull out the jumpers located next to the speaker terminals located on the outside of the case.

Welcome btw

thx.

do taking them out make them louder or lower? I'll look in the morning.

I don't remember, try pulling them out and listen for any differences in output.

they were hell to get out. that lower the level. those jumpers suck. I will replace them with hdd jumpers if I use them again

thx again