Page 1 of 1
does anyone know the ohm load on the Elite 6.5 drivers?
Posted: Mon Jul 30, 2007 7:35 pm
by gentlejax2
I might try a different driver with the xover but I dont know what the ohm load is on the mid in the 6.5 Elite set
Mike
Posted: Tue Jul 31, 2007 8:40 am
by gentlejax2
really need to know this....is it on the slim to none owners manual?
Mike
Posted: Tue Jul 31, 2007 8:47 am
by VW337
Do you need the driver or system impedance?
I think the driver is ~4.2 and the system is ~3.6
Posted: Tue Jul 31, 2007 12:00 pm
by gentlejax2
I need the driver impedance so if I try out some other mids (Image Dynamics) then I will not fry the xover.....maybe...
of course I need to know the frequencies of the xover and the drivers
Posted: Tue Jul 31, 2007 12:24 pm
by Bfowler
i was trying to pin point a problem in my System not to long ago and the ti mid was either 3.6 or 3.8....(will it make that much difference?)
Posted: Wed Aug 01, 2007 10:13 pm
by ericb
never add another driver to a passive crossover that's not 6 db per octave. it can screw the frequencies up and possibly cause ringing.