Page 1 of 1
Free RTA?
Posted: Sat Aug 04, 2007 7:38 pm
by Stereo Junkie
Howdy!
I am trying to set my TiDEQ now that it is installed and I need a free RTA program to run on my laptop. Any suggestions or ideas?
Big thanks,
Stereo Junkie
Posted: Sun Aug 05, 2007 7:48 am
by 444 FED
I did find a free half octave IIRC RTA program, but the Mics were not free, though they did show ways to use cheaper mics, I woud imagine the accuracy to not be close enough.
If I find teh link again, I'll post.
Posted: Sun Aug 05, 2007 12:53 pm
by brenzbmr@sb
spend the money and buy a term lab..........
just buy one sensor and the rta program.
Posted: Sun Aug 05, 2007 1:15 pm
by Stereo Junkie
Given that I have been out of my last corp job since Feb and I am trying to start my own company, money is a little "tight". Thus my search for a free RTA. If I had the money I would buy TrueRTA at 1/3 octave.
Stereo Junkie
Posted: Fri Aug 10, 2007 8:27 am
by Stereo Junkie
I hate to bump my own post but I have scoured the web looking for a free RTA to setup my system, but to no avail. Is there anyone here on the forum with any information?
Thanks,
Stereo Junkie
Posted: Fri Aug 10, 2007 11:33 am
by VW337
try this--
Posted: Fri Aug 10, 2007 2:06 pm
by Stereo Junkie
Erinn,
Thanks for the input. I had previously attempted to use this one but I don't seem to be able to find a way to keep it graphing the audio, only in short "test" burst that then graph the data. Additionally there does not seem to be a bar graph 1/3 octave option.
Perhaps I am overlooking it? I am sure I don't know how to use this program correctly. Any information you or some else can offer would be of great benefit.
Thanks,
Stereo Junkie
Posted: Fri Aug 10, 2007 2:12 pm
by fuzzysnuggleduck
Generally an RTA will send a known signal of a specific length (a burst) to the stereo and then "listen" to what it actually plays with a highly sensitive mic.
The software then graphs the response as it "hears" it through the mic on a frequency/time plot.
You then can go a head and adjust your EQ to compensate where you need to and run the test again. Compare differences.
Something like that.
Posted: Fri Aug 10, 2007 2:56 pm
by VW337
I have no idea how to use the software I uploaded. I tried it once, to no avail.
You may want to see if you can locate a "spectrum analysis" software and set it to your mic input and use a calibrated mic. I know some programs such as media player have spectrum analyzers built in, and you may be able to take advantage of this.