Ti600.2 power at bridged 2 ohm load

E350Titanium · Post by **E350Titanium** » Fri Sep 07, 2007 2:29 pm

The birthsheet of my Ti600.2 states 627 watts bridged into 4 ohms but i would like to know what the rough wattage would be into bridged 2 ohm.

I'm trying to sell this amp to a guy who wants need to run a single 12" sub at 2 ohms.

I did run 2 10" 4 ohm subs into bridged 2 ohms without any problems.

Oh thanks for sending George W Bush to Sydney.
We got an extra public holiday on Friday.

Post by **Bfowler** » Fri Sep 07, 2007 2:37 pm

it will run fine at 2ohms, but the amp has a built in currant limiting circuit that wont allow it to make much more power at 2ohms.

make sure he he is using some beefy power wire and gives it a little breathing room for the fan if he is going to run it like that

E350Titanium · Post by **E350Titanium** » Fri Sep 07, 2007 2:42 pm

So around the 627 watts is about it then.

Still plenty though. It bumped nice for me when i was using it.

Post by **Bfowler** » Fri Sep 07, 2007 2:45 pm

^exactly, most think they can get much more power out of it at 2ohms, but it will be about the same as the 4ohm output

E350Titanium · Post by **E350Titanium** » Fri Sep 07, 2007 2:48 pm

Thanks B

Post by **AVICJR** » Fri Sep 07, 2007 2:55 pm

E350-- Do you mind posting pics of that install in the E320?

E350Titanium · Post by **E350Titanium** » Fri Sep 07, 2007 2:58 pm

No problem i'm not on my computer at the moment but when i get on mine i'll post them up.