Phoenix Gold Phorum

The birthsheet of my Ti600.2 states 627 watts bridged into 4 ohms but i would like to know what the rough wattage would be into bridged 2 ohm.

I'm trying to sell this amp to a guy who wants need to run a single 12" sub at 2 ohms.

I did run 2 10" 4 ohm subs into bridged 2 ohms without any problems.

Oh thanks for sending George W Bush to Sydney.
We got an extra public holiday on Friday.

it will run fine at 2ohms, but the amp has a built in currant limiting circuit that wont allow it to make much more power at 2ohms.

make sure he he is using some beefy power wire and gives it a little breathing room for the fan if he is going to run it like that

So around the 627 watts is about it then.

Still plenty though. It bumped nice for me when i was using it.

^exactly, most think they can get much more power out of it at 2ohms, but it will be about the same as the 4ohm output

Thanks B

E350-- Do you mind posting pics of that install in the E320?

No problem i'm not on my computer at the moment but when i get on mine i'll post them up.