Firewall
Posted: Wed Sep 12, 2007 12:00 pm
What do you guys use to get through the firewall to run power wire?
Unibit and an old one-piece antenna.bdubs767 wrote:What do you guys use to get through the firewall to run power wire?
Phoenix Gold Phorum
Celebrating the Phoenix Gold legacy, and oldschool car audio!
https://www.phoenixphorum.com/
Firewall
Page 1 of 1
Re: Firewall
Posted: Wed Sep 12, 2007 12:32 pm
Posted: Wed Sep 12, 2007 4:48 pm
horse whip and duct tape 
Posted: Wed Sep 12, 2007 4:55 pm
I found an existing hole. It was a big 2-3" hole with a rubber grommet feeding an electrical line to the cabin. I cut a tiny hole, and put a little dish soap and pulled it through taping a small piece of hangar wire on the end to keep it straight.
Posted: Wed Sep 12, 2007 5:02 pm
Problem I had with my Tiburon is there are no, repeat no, places in the firewall you can run amp cable. Under inspection I realised that the entire fucking loom runs through the driver side fender 
They stopped this after the RD tiburon because if you get fender bendered there and the loom gets severed badly enough the car will be considered a total
Was a right horrible bastard to get the 4awg through and into the footwell.
They stopped this after the RD tiburon because if you get fender bendered there and the loom gets severed badly enough the car will be considered a total
Was a right horrible bastard to get the 4awg through and into the footwell.
Posted: Wed Sep 12, 2007 9:06 pm
what car?
second is use a existing grommet that has all the wires in it,
third a unibit and a good location on the firewall works for me
use a gromment and silicone the opening and you should be fine
depends on the car though
second is use a existing grommet that has all the wires in it,
third a unibit and a good location on the firewall works for me
use a gromment and silicone the opening and you should be fine
depends on the car though