Are these amps real good?
Im with a Doubt.Does exist any difference (in inside, constructions and materilas) between QX4.150 and QX300.4?
In case of yes, wich would be better to power a comp kit?
thanks!
Phoenix QX Series?
-
fordtough1
- Twisted's Boyfriend
- Posts: 1438
- Joined: Fri Feb 23, 2007 7:07 pm
- Location: Are we there yet?
QX series used to be PG's low end line. However, they still were not bad amps for the low price point. Just comparatively, they had the QX, XS, and ZX lines out, so QX was the bottom. As for the internals, they were not overly built. You can see a pic of the 4150 here:
http://ampguts.realmofexcursion.com/Pho ... d_QX-4150/
As for what would be better to run components, Im not too sure you have your model number right. I have never heard of a QX 300.4, and the way that they named these amps iot does not seem to make any sense. I will tell you this though, those amps were never huge on the headroom, so 50w per channel may not be enough depending on the components. It (4150) would run them fine in bridged mode though (150 watt X 2)
http://ampguts.realmofexcursion.com/Pho ... d_QX-4150/
As for what would be better to run components, Im not too sure you have your model number right. I have never heard of a QX 300.4, and the way that they named these amps iot does not seem to make any sense. I will tell you this though, those amps were never huge on the headroom, so 50w per channel may not be enough depending on the components. It (4150) would run them fine in bridged mode though (150 watt X 2)
-
Bfowler
- Briaans..... BRIAAAAANNNNNNS
- Posts: 10769
- Joined: Wed Dec 06, 2006 11:06 am
- Location: So easy, a cavewomen could do him
they were fine amps. the design was carried over to the octane-r amps and ryval amps. the don't have much headroom, or special features, but they make their rated power for an excellent price.
what components are you running?
likely they will work more then fine. 50 watts and a high pass crossover is more then adequate for most people. especially when moving up from a stock system
what components are you running?
likely they will work more then fine. 50 watts and a high pass crossover is more then adequate for most people. especially when moving up from a stock system
my ex-girlfriend said "its car audio or me"
i've had tougher choices at a soda machine...
i've had tougher choices at a soda machine...