Phoenix Gold Phorum

ok so i got every thing installed tonight (will post pics tomorrow )
and i put in the 1st cd of the set mrtibbs sent out and well obout 1 1/2 minutes of mild volume this power hungry mofo droped my volts to about 9v and poped the 100 amp fuse.

so what do you guys recomend for fuse size? oohh yea and it was soundin pretty damned GOOD

Size wise I said a M-100 was located between a MS-275 and a MS-2125. The MS-275 calls for a 40 amp fuse, and the 2125 has 120 amps internal fusing 2 X 60 amps, SO my big question is where you think your going with a 100 amp fuse my friend ?????

I would think a 80 amp fuse would have been enough, Even at 9 volts X 100 amperes your poring 900 watts into a 200 watt amp

And it still has all of its smoke inside of it ????



OH and if it was a KF wafer style fuse, they are good for 200% for a few moments before they even warp from excess heat let alone blow open clean. Wafers are very durable and when I use then I specifically under fuse my amps by a 30% margin < Fuses are cheap Cecil's amp repairs are expensive