copper or brass plate?
Posted: Thu Oct 25, 2007 9:47 am
what material is this? i'm doing a repair very similar to this on an m50 like eric did and need some material to make some buss bars! pics to follow....
Phoenix Gold Phorum
Celebrating the Phoenix Gold legacy, and oldschool car audio!
https://www.phoenixphorum.com/
copper or brass plate?
Page 1 of 1
Posted: Thu Oct 25, 2007 9:58 am
He used copper.
Posted: Thu Oct 25, 2007 11:07 am
I think that is some thin brass plate material he found at a local supplier. Try PM'ing him I am sure he will answer. C 
Posted: Thu Oct 25, 2007 2:00 pm
That is brass. I think it is 0.01” thick, but I cannot remember for certain. Brass is much harder than copper, so it will hold its shape, and it still solders well if you use flux.
I don’t frequent many online forums anymore, so sending me a PM will likely not get you any answer quickly. However, if anyone ever has a question for me, they are more than welcome to shoot me an email.
dr.fosgate@gmail.com
I check my email several times a day both at home and at work. Many weekends I don’t get around too it, but with the onset of winter, I will probably be around plenty.
I don’t frequent many online forums anymore, so sending me a PM will likely not get you any answer quickly. However, if anyone ever has a question for me, they are more than welcome to shoot me an email.
dr.fosgate@gmail.com
I check my email several times a day both at home and at work. Many weekends I don’t get around too it, but with the onset of winter, I will probably be around plenty.