Phoenix Gold Phorum

Hi Guys

while chatting to some of the guys I found there is a demand for the power blocks which came on the M100 , the MS2250 MS2125 and such , since PG cannot or does not have any left , I was looking at this amp



The terminal looks the same from the outside, but the inside solders to the board, I am thinking a good engineering shop could machine out the required bits and then u could retro fit it .

dunno if it would work, but I am sure guys like doc or C will have a better idea

That might work, but there are no mounting tabs for screws.

Yeah , seen that now, but I am sure there is a company which makes this item, perhaps they can steer us in the right direction.