Page 1 of 1
spl install
Posted: Thu Nov 15, 2007 1:06 pm
by bdubs767
For a friend's install he wants it loud and thats it. So Im desinging him a ported box with two RSd12ds off a x1200.1, but Im wondering if I should fire the box into the cabin and seal the subs off from the trunk or should I fire the subs backwards towards the end of the trunk.
What have you guys found to work better?
Posted: Thu Nov 15, 2007 1:10 pm
by RATIFIED
From past experiences, I've found firing them into the trunk does better. Gives it a small cabin gain effect.
Posted: Thu Nov 15, 2007 4:22 pm
by Bfowler
If he can fold his seats down.....seal them in to the cabin firing forward.
you could slot load them into a vent in the rear deck.......
Posted: Thu Nov 15, 2007 9:50 pm
by brenzbmr@sb
if your looking for overall pressure then sealing the trunk from front of baffle or
what they call walling off your trunk is the best solution
Posted: Fri Nov 16, 2007 9:20 am
by Mackenzie
I would personally do subs back, aero ports to the side.. If he doenst want to do aeros, I would probably just fire both the subs and port to the rear of the car, with tons of port area..