Phoenix Gold Phorum

Ok, I have this idea to run two x600.1 amps for sub duty, one to each sub. Is there a way to use one LPL knob to control both amps? I'm not running any signal processors that have a place for the LPL.

I thought about building my own and using two seperate phone cables coming off of it, but I'm not sure this would work. If it will work will I need a different resistance of potentiometer to control both amps, or will the 10k ohm be the right size?

Any ideas guys?

Use one with the LP filter enabled and plug the LPL into it. use its signal out to send signal to the other amp which will automatically be "lpl'ed"

Thanks guys

I had seen that splitter thing before and just forgot.

Brian, that idea is too damn simple, I wanted to make it more difficult than it had to be.