Page 1 of 1
What's a MX2 TWO WAY ELECTRONIC CROSSOVER?
Posted: Wed Nov 28, 2007 11:31 am
by SCHAFRANEK
I'm kinda new to all this ICE so I hope somebody out there will answer a simple question for me.
What is a Phoenix Gold MX2 2-way Electronic Crossover and what can I do with it?
My setup is M44 + M25 + EQ215x at the moment. Will the crossover be of any use to me?
-thanks-
Posted: Wed Nov 28, 2007 11:38 am
by fuzzysnuggleduck
You already have crossovers in the M44 and the EQ215x so you don't technically need it.
Posted: Wed Nov 28, 2007 11:41 am
by SCHAFRANEK
OK. Thats all I wanted to know, thanks.
I might just buy it anyway. It's cheap and its PG
Posted: Wed Nov 28, 2007 12:23 pm
by fuzzysnuggleduck
For info on your EQ125x crossovers refer to this documents:
http://download.phoenixphorum.com/Manua ... 5x_230.pdf
For info on the MX2, refer to this document:
http://download.phoenixphorum.com/Manua ... manual.pdf
The main difference is that the MX2 uses potentiometers to set the crossover point whereas the EQ215x uses RNETs. If you don't know what an RNET is, it's basically a bunch of resistors soldered to a removable connector thing. By using different resistor values, you get a different crossover point.
Apparently the RNETs are more accurate than pot-based crossovers but they are certainly more involved to work with as you have to replace small internal parts to set the crossover point instead of twisting a knob.
Posted: Wed Nov 28, 2007 12:44 pm
by thingy
SCHAFRANEK wrote:OK. Thats all I wanted to know, thanks.
I might just buy it anyway. It's cheap and its PG
HEHE got you hooked to this forum huh ? - anyways - i had an idea for the use of a mx2 xo so pm at bilstereoforum if youre interessted
Posted: Wed Nov 28, 2007 1:08 pm
by SCHAFRANEK
thingy >
PP is my new fix