Page 1 of 1
Elite 6 crossover point
Posted: Thu Dec 06, 2007 5:57 am
by perseus417
Well I got the components all installed. Sealed and deadened the doors. I have an Eclipse Head unit that has some crossover points on it 63, 80, 100 and when I set the sub, it automatically sets the highs at the same point, I can't choose different crossover frequencys. Right now I have it set at 63 hz and 12 db slope (as steep as it will allow). My question is, is this too low a frequency for the mids? Im running about 150-170 wrms to them. Should I keep it at 63 or maybe bump it up to 80?
Posted: Thu Dec 06, 2007 7:18 am
by stipud
Do whatever sounds best. The Elite 6 can definitely play down low if installed properly, but it won't have the force or impact of a subwoofer.
Posted: Thu Dec 06, 2007 7:20 am
by bdubs767
63hz with 2nd order slope is kinda pushing it for 6 1/2"...personally Id bump it up to 80hz but like Tom (the lobster) said if it sound sgood it sounds good.
Posted: Thu Dec 06, 2007 7:23 am
by perseus417
Ok, I'm going to bump it up to 80hz next time I get in the car to be a little more safe. Thanks.
Posted: Sat Dec 08, 2007 8:35 am
by smgreen20
I have an Eclipse CD8455 HU and obviously the Xover function is different in yours. If I recall, I have my Elites set at 63Hz at 24dB. I can store up to 5 different xover/eq settings and the one mentioned above is my number one choice.
The number 2 setting I have the Elites x'd over at 80Hz @12dB. Some music I listen to sounds better at that. Blessthefall I have to listen to at that seting.
Then again my sub xover point is independent from that of the mids.