Page 1 of 1
tld/basscube question
Posted: Tue Dec 11, 2007 8:19 pm
by fordtough1
Does it matter which order I put these in? I was going to run from the headunit to the basscube to the linedriver. Would it be better to go headunit to linedriver to basscube? Or does it not really matter at all.
Just curious.
Posted: Wed Dec 12, 2007 8:32 am
by rolandk
In your case it won't matter. If you had an external crossover then it would be best after the crossover, so the higher range of boosted freqs don't bleed into the mids.
Posted: Wed Dec 12, 2007 8:48 am
by Bfowler
it seems like a waste of line driver to use it after the bass cube. but it will work either way
Posted: Wed Dec 12, 2007 9:21 am
by fordtough1
My concern was that I will be using a headunit with 5 volt outs, and I heard that the linedriver could drive that to 10, but the basscube says maximum 8 volt in. I didn't know if it would hurt the basscube to have the higher input voltage.
Posted: Wed Dec 12, 2007 9:30 am
by Bfowler
I didnt think about the bass cube only taking 8...
the line driver CAN put out 10volts there are pots on the inside that you could turn down to 8. I forgot what amps are you using?
Posted: Wed Dec 12, 2007 10:14 am
by fordtough1
I'll be using an x200.2 for the fronts and an x1200.1 for subs
Posted: Wed Dec 12, 2007 10:22 am
by Bfowler
ah....in that case....get those 10 volts...use the bass cube first.
i should learn not to question Roland's advice
Posted: Wed Dec 12, 2007 10:26 am
by fordtough1
That's what I thought, but I wanted to make sure.