Phoenix Gold Phorum

Posted: **Sat Jan 12, 2008 8:00 pm**

anyone?

Posted: **Sat Jan 12, 2008 8:07 pm**

The manual says 142 mm which converted to inches is: 5.6"

Posted: **Sat Jan 12, 2008 9:42 pm**

thanks, I am too blasted to look for that...

Posted: **Sun Jan 13, 2008 5:16 pm**

can a mod delet this thread, I dont remember making it...

Posted: **Mon Jan 14, 2008 7:10 am**

Ahsmo wrote:can a mod delet this thread, I dont remember making it...

All the more reason to keep it open.

Look everyone! Our little buddy Ahsmo got drunk. Isn't that cute

Posted: **Mon Jan 14, 2008 9:33 am**

6.5 inches minus a little bit.

Mods can delete, but the ones in here are kick-ass, amazing and quite good-looking.

Posted: **Mon Jan 14, 2008 5:09 pm**

7" hole, flush mount install, use duct tape around the edges.

Posted: **Tue Jan 15, 2008 9:21 am**

HoseHead wrote:6.5 inches minus a little bit.

Mods can delete, but the ones in here are kick-ass, amazing and quite good-looking.

well thank you bruce, that was sweet and honest of you to say. I'm surpised to see you say that

cut out size for rsd 6.5 comps