Phoenix Gold Phorum

Hello, I have to connect two different amp (one for left and right channels and one for sub) at the same two Source line out. Firts amp is a PG MS275 and second ones is Alpine AMP, how can I do it ?

with master and slave connection ?

Thanks in advance

does the alpine amp have an input and output? if not you can use y-rca's to split the signal from the source rca into two. or get an outboard crossover that will take the one signal and split it into two or three outputs.

I hook up 3 amps and i use just Y-splitters, thats working well for me.

here is a posting for a MX2, takes a single rca input and converts it to two outputs, one high pass, one low pass.

http://phoenixphorum.com/fs-pg-mx2-and- ... t5048.html