2 amps, 1 sub
Posted: Tue Mar 18, 2008 7:54 pm
Is it really possible to set up 2 amps to run a DVC sub?
Phoenix Gold Phorum
Celebrating the Phoenix Gold legacy, and oldschool car audio!
https://www.phoenixphorum.com/
2 amps, 1 sub
Page 1 of 1
Posted: Tue Mar 18, 2008 7:56 pm
Yep, many people here have done it with the TI Elite!
Posted: Tue Mar 18, 2008 8:00 pm
Yeah, but I wanna use a sub with some real outputmr tibbs wrote:Yep, many people here have done it with the TI Elite!
Posted: Tue Mar 18, 2008 8:05 pm
YES, but you have to make sure the outputs of both amps are perfectly matched or the VC will get all fucked up.
Posted: Tue Mar 18, 2008 8:10 pm
300 watts per VC = 600 watts?
Posted: Tue Mar 18, 2008 9:29 pm
pff for 600w you need only one amp
Posted: Tue Mar 18, 2008 10:59 pm
Yes, if each amp is putting out 300W then you're putting "600W" on the sub.
Make sure you gain match the amps with a DMM. Normally I'd say the DMM is nice but unnecessary, however; In this case, I think it's necessary to do it "right".
Make sure you gain match the amps with a DMM. Normally I'd say the DMM is nice but unnecessary, however; In this case, I think it's necessary to do it "right".
Posted: Wed Mar 19, 2008 3:38 am
That's the problem I'm facing with hooking up a ti500.4 to 2 DVC subs; on a smaller scale of course.
1 channel per VC
1 channel per VC