Phoenix Gold Phorum

i have an EQ232 in my system and the other day it stopped working.

sorry about the dbl post

i ran through the trouble shooting and still nothing, anything else i can do? or do i just have to replace it?



just so you know what its going in (i need it working soon, show coming up)

It has a fuse inside it, remove the cover and try replacing that first. If it fails again it will fairly quickly if it does. You can send it to PG/Rodin for a flat rate of repair. I think the price is $85.00 US.....You have to call them to get a RMS #, have a CC ready.

I have repaired a few of these over the years, mostly simple stuff like a failed IC, or a failed power supply. All pretty straightforward stuff, and YES defiantly worth the effort to repair. I Own 5 of these....


PS let them know its a RUSH job to be used in a show. They are pretty nice about things like this I am sure.

so try the fuse inside first? i will try that tomorrow and see how it goes, what is the likely hood of that being the problem? cus its getting 14.4 volts of power and then the remote is good. the ground is good. so would that be it?

ok so i just looked, the fuse did blow, does anyone know what amp fuse it is?

Its supposed to be a 2 ampere fuse ..

If it blows again you most likely have a bad power supply issue. I have replaced the toroids on these before. They can be bought from PG for about $7.00 each last I checked. And the two fets in front of the toroid will be bad also.
It happens sometimes when the toroid windings short on themselves, they take out the driver Fets also.

If the above is the case it will blow the fuse again right away, as a symptom of this trouble.

PG is pretty good about fixing these, and even I would have to order parts from them to get this repaired, So PG is your fastest ticket if thats whats wrong....