Page 1 of 1
Who made those MS-heatsinks?
Posted: Wed Apr 02, 2008 9:28 pm
by Pedi
Since there are alot of guys here with alot of info about the MS-amps, I must ask:
Who was the producer of the MS-heatsinks? Is there a company to contact?
Posted: Wed Apr 02, 2008 10:04 pm
by Rold Gold
Anybody that has an MS and is willing to pay for CNC time is really what it comes down to. These days it's not hard to replicate things if you have the $$$$.
Hell, a guy could have sinks made in 6 foot runs and LIGHTER with a 275 for a template. That might actually be worth looking into.... It just so happens that I know a guy with a CNC not doing anything in his shop.
Posted: Wed Apr 02, 2008 10:11 pm
by Pedi
FuzzyHoNutz wrote:Hell, a guy could have sinks made in 6 foot runs and LIGHTER with a 275 for a template. That might actually be worth looking into.... It just so happens that I know a guy with a CNC not doing anything in his shop.
Lets make him busy!!!
Posted: Thu Apr 03, 2008 3:05 am
by Ahsmo
Eric has/had the resource to tool a heat sink like that and he also had the tools to cut out the end plates.
The stock for that would be $$$$$$$$$$$$$