Phoenix Gold Phorum

ok....I didnt realize it had that many options for the xover controls...

I dont need to run anything special....just a passive system...all 4 channels driven in high pass mode ...

I have a front and rear input off the deck and 0 crossover off the deck....

can I get a hand in setting all these buttons...

http://download.phoenixphorum.com/Manua ... /zx450.pdf


haha...

You want them all out, except the rear bypass feed (push that one in) and the frequency select is your choice, the x10 would normally be used for tweeter higher pass. I sometime get cofused 9or accident hit buttons)when install them and just figure it out on the spot.

all ou except the rear bypass feed? thanks .....

Look at the schematic on page 7 for example. you see the x-over for 1 channel. just follow your leading path to the end en push those buttons.

I had to look also for 3 times before I got it, but know I'm playing with it!