Page 1 of 1
100.4 or 200.2 ?
Posted: Thu Apr 10, 2008 2:55 pm
by gentlejax2
is one any better than the other? I would run the 100.4 bridged of course...but is there any advantage of one or the other as far as build?
Posted: Thu Apr 10, 2008 2:58 pm
by Bfowler
nope. the 200.2 is a bit smaller....
if you ever wanted to bridge it, the 200.2 would give you more power into 1 channel...
thats about all i can think of
Posted: Thu Apr 10, 2008 3:09 pm
by gentlejax2
would a 200.2 like a 6ohm load? I guess so ....I just wonder what it would put out due to the xe load....?
I guess I havnt researched the xe load....but I got some 6ohm Orion XTR mids I want to try.....but I havnt figured out how I am going to due that...
I mean to say I will need to figure out the crossover situation or just run it right off the amp if possible...
I am going to run a set of mids off a 200.2
Posted: Thu Apr 10, 2008 4:22 pm
by Francious70
A 200.2 with 6 ohms would put out around 150x2. A 100.4 bridged with 6 ohms will put out 200x2.
Thank you XeLoad.
Posted: Thu Apr 10, 2008 4:32 pm
by gentlejax2
is that true? I might have to get one of each...
Posted: Fri Apr 11, 2008 8:13 am
by Bfowler
yep^ because each channel on the 100.4 will do 100 watts from 1-4 ohms, a 6ohm bridged load is the same as 3ohms on each channel (stereo)
so the 100.4 will do 200 x 2 up to 8ohms
Posted: Fri Apr 11, 2008 2:37 pm
by dejo
I was stupid and got rid of one of my 100.4 and cant trade back for it because it will make 8 ohm power and my buddy wont come off it.