Page 1 of 1
ZPA0.5 v1 VS ZPA0.5 v2
Posted: Fri Jul 11, 2008 5:21 am
by flogger11
What changes did they make on the v2? Thanks guys! Mike
Posted: Fri Jul 11, 2008 6:26 am
by stipud
It was similar to the ZX series changes... mostly just to the fan. I don't recall the exact changes otherwise though. I do know it is quite possible to convert up to a V2 in either amp.
Posted: Fri Jul 11, 2008 7:30 am
by rolandk
Nothing major-
Replaced the power and speaker terminals if they had a hole all the way through (newer style is blocked off in the back to prevent debris from falling on PCB).
Updated some component values in the power supply to prevent heat stress.
Fans.
Removed ground switch and hard wired to 'ground' position.
Posted: Sun Jul 13, 2008 8:42 pm
by evo9
rolandk wrote:Nothing major-
Replaced the power and speaker terminals if they had a hole all the way through (newer style is blocked off in the back to prevent debris from falling on PCB).
Updated some component values in the power supply to prevent heat stress.
Fans.
Removed ground switch and hard wired to 'ground' position.
Roland,
I am in need of a pair of power terminals. I have a .5 with the pass thru type. I would like to repalce them.
.
Posted: Mon Jul 14, 2008 7:30 am
by rolandk
Talk to Phil the Service Manager and see if he has any. They are very hard to come by these days so he may or may not.
Posted: Mon Jul 14, 2008 9:15 am
by marko
evo9 wrote:rolandk wrote:Nothing major-
Replaced the power and speaker terminals if they had a hole all the way through (newer style is blocked off in the back to prevent debris from falling on PCB).
Updated some component values in the power supply to prevent heat stress.
Fans.
Removed ground switch and hard wired to 'ground' position.
Roland,
I am in need of a pair of power terminals. I have a .5 with the pass thru type. I would like to repalce them.
.
just solder some thin brass on the ends...
i compared a v1 to v2 a while ago, there's actually a lot of differances when you start taring them apart...
Posted: Mon Jul 14, 2008 3:29 pm
by smgreen20
They also did away w/the ground/floating switch.