Page 1 of 1
ti 900.7 amp
Posted: Sun Aug 03, 2008 12:38 pm
by stuartyp
Hi am am new to the site and was wanting to get some advice if poss. I have just bought a ti 900.7 amp and i am wanting to run a set of boston acoustics z6 speakers active of this amp and to run my sub too .The only thing worrieing me is that the boston z6's run at 3ohm.Will this be possible and what would it sound like for sq competitions thanks stuarty
Posted: Sun Aug 03, 2008 12:52 pm
by fordtough1
Welcome to the phorum. I'm not very familiar with active setups, but there are several guys on here that are, and several that have a 900.7. I know it is a very versatile amp, and I think you will be very happy with it, I know I was happy with my Ti stuff when I had it.
It's a little slow around here on the weekend, but be patient, someone will answer your questions and give some advice...

Posted: Sun Aug 03, 2008 12:59 pm
by stuartyp
Hello thanks very much always liked pg stuff had a few bits sold them and went to all boston now i am coming back round to pg stuff.Dont get me wrong i love the sound of the boston z's dont think i could do away with them
Posted: Sun Aug 03, 2008 10:11 pm
by stipud
3 ohms should be no problem. Bridge the front and rear channels to run your comps; you will need some Y-splitters to do this. Then bridge your sub channels for 2 ohms. Plenty of power. If you want rear fill, run it mono off the center channel output.
Posted: Mon Aug 04, 2008 10:43 am
by stuartyp
I was thinking of running the tweeters of the front output of the amp and the mids of the rear to go active in the car.Do you think this would work thanks stuart
Posted: Tue Aug 05, 2008 7:00 am
by stipud
Sure, that's possible, but you will need an external crossover of sorts. I think that crossover is bi-ampable as well, isn't it?
Posted: Tue Aug 05, 2008 10:48 am
by shaheen
No need for external X-Over, the 900.7 has a switch which allows you to go bandpass as well las x10 on the X-Over.
This will allow you to go full active, but I would scope and RTA the output to check the actual x-over point.
Posted: Tue Aug 05, 2008 11:17 am
by stipud
Thanks shaheen, you're right! I totally forgot my 900.7 had the same crossover features as the 500.4.

Posted: Tue Aug 05, 2008 12:01 pm
by stuartyp
i have the alpine f1 headunit and processor so that is going to do all the crossovering i need just powered it up to check it all works and it does so happy days.I didnt think this amp was so big

but its great
