Page 1 of 1
What freq cutoff do you guys recommend on my crossover
Posted: Sat Nov 08, 2008 1:27 pm
by finkle636
for a 6.5" RSD component set
and a 4" coax RSD?
Posted: Sat Nov 08, 2008 1:31 pm
by bretti_kivi
do they come with standard XOs? or are you going to run active?
Posted: Sat Nov 08, 2008 1:37 pm
by finkle636
the components are standard and i'm just lookin at what to set the xenon amp to
The 4" coax dont have an external crossover
Posted: Sat Nov 08, 2008 1:42 pm
by gkitching
Set to HP at 55/60 for the comps and HP at 120 for the 4's. That's kinda the general starting point. Don't be afraid to try, listen and make changes to get a feel for how they work for you.
Posted: Sat Nov 08, 2008 5:07 pm
by maka78
I don't know much about the RDS line, but the TI6 Elites sound amazing at 100 Hz HP on an x200.4. Any lower then that and they start to sound sloppy.
Posted: Sat Nov 08, 2008 7:01 pm
by fordtough1
I've got my RSD 6.5's crossed at about 75 and I'm pretty happy with them. I need to do some tinkering to see if they sound better a little higher or lower though. I've just been too lazy to mess with it.