Page 1 of 1
Build Question
Posted: Thu Dec 04, 2008 5:22 pm
by bigbluefj
So what i have for a amp is an MPS 2500 and what i was woundering is what amp should i match up with the MPS?? the 2500 will run the front and what to use for the back will be running 4-10" or 4-12" sub's????
MS2250 MS1000 or ????
Posted: Thu Dec 04, 2008 5:26 pm
by mr tibbs
What vehicle will this be going in?
Posted: Thu Dec 04, 2008 5:43 pm
by Rold Gold
MS1000................
Posted: Fri Dec 05, 2008 12:51 am
by mhyde71
i bet it's a Blue FJ Cruiser ... I could be wrong tho- just taking a guess.
BUT yeah What he said ^^^^
4-subs' sounds like maybe a job for a MS1K
think kinda need to know more info tho- i.e. SVC/DVC, Watts desired by what for what?? stuff like that5...
Do you have a MS1K?
Posted: Fri Dec 05, 2008 8:06 am
by stipud
Use the MPS2500 on the subs. You want 4 subs... get some SVC 4 ohms (or DVC 2 ohms wired in series) and wire them all in parallel for a 1 ohm final load. The 2500 would produce a solid 750 or so watts at that level.
Then you can get something like an MS275 or MS2125 to run your front stage. Much better suited for the higher impedance of component speakers.