Phoenix Gold Phorum

I'm going to purchase front RSd65cs components for my subaru, and was stumped on which amp would be optimal for these speakers.

I was looking at the possibility of getting this one and bridging it, but wasn't sure if this would be the best setup. Any recommendations? Would this be a good choice?


Phoenix Gold RSd300.4
[/img]http://www.onlinecarstereo.com/UIContro ... d3a842f5fe[/img]
50Wx4 4-Channel Car Amplifier
# RMS Power Range : 48-300 Watts
# Number Of Channels: 4
# Low Frequency response: 20 Hz
# High Frequency Response: 20000 Hz[/url]

Are ya planning to replace/power the rear also? I'd say a Zenon 100.4 would do the job. But a 200.4 would really do it too.

no for now i'm just doing the fronts and might just fade out the rears.

The RSd300.4 bridged would be just fine. Very similar to my M44 bridged, which is great.

There are lots of amps that could do the job well, but if you want a new amp right now at a low cost with high performance, the RSd300.4 is great. Want a little more power or options for the future? Go with the RSd500.4

^^^^^^^YEP............

how loud do you like it? anything from 50 watts to 200 honestly. i have even ran them on deck power and they sounded decent. they are verital and awesome