Page 1 of 1
Specs sheet for a cyclone
Posted: Sat Jan 31, 2009 2:58 pm
by joerg
I need to know all the Thiele/Small parameters to calculate the housings for my clones! I will mount them inside out so that they are fully visible! Cutoff frequenzy will be at 48Hz and they should have the peak pressure level at 37 to 38Hz. All suggestions and scans are welcome
Posted: Sat Jan 31, 2009 3:36 pm
by shaheen
The bigger the better, if you going to mount them inside out then I suggest 2.5cu ft to 3.0 cu ft.
If they inside then add on another 0.5Cu Ft
the Spec sheet I think is in the downloads section
Posted: Sat Jan 31, 2009 3:37 pm
by shaheen
Posted: Sat Jan 31, 2009 8:48 pm
by ttocs
the one and only box I got to build for one was 3 cu ft. That thing hit like crazy and was great when we matched it up with a 10. Sounded much better with the trunk shut.